Before You Begin; Select A Power Source - Printronix p4280 Setup Gudie

Before You Begin...

Read this chapter carefully before installing and operating the printer.
The P4280 IPDS printer is easy to install, but for your safety and to protect
valuable equipment, perform all the procedures in this chapter in the order
presented.

Select a Power Source

The printer must be connected to a power outlet of 100–120 VAC or
200–240 VAC at 50 or 60 Hz. The P4280 IPDS printer automatically senses
and adjusts itself to conform to the correct voltage range.
Primary circuit protection is built–in: the power switch is also a circuit
breaker.
Consult an electrician if printer operation affects local electrical lines. See
Appendix A for power specifications.
It is recommended that printer power be supplied from a separate AC
circuit protected at 20 amperes for 120 volts, or 10 amperes for 240 volts
at 50 or 60 hertz.
Setting Up the Printer
IMPORTANT
2–3