Seagull Models X-RAY Assembly Manual page 13

INSTALLING THE BATTERY-RECEIVER.
See pictures below.
Tie wrap or rubber band.
Battery tray
Battery.
Screw.
ATTACHMENT WING-FUSELAGE.
Attach the aluminium tube into fuselage.
Insert two wing panels as pictures below:
www.seagullmodels.com
Tie wrap.
Receiver.
Wing bolt.
Wing bolt.
BALANCING.
!1) It is critical that your airplane be bal-
anced correctly. Improper balance will cause
your plane to lose control and crash. The cen-
7cm
ter of gravity is locate
ing edge of the wing, measured at wing tip.
!2) If the nose of the plane falls, the plane
is nose heavy. To correct this first move the
battery pack further back in the fuselage. If
this is not possible or does not correct it, stick
small amounts of lead weight on the fuselage
sides under the horizontal stabilizer. If the tail
of the plane falls, the plane is tail heavy. To
correct this, move the battery and receiver for-
ward orif this is not possible, stick weight onto
the firewall. When balanced correctly, the air-
plane should sit level or slightly nose down
when you lift it up with your fingers.
back from the lead-
13