Danfoss ECL Comfort 210 Operating Manual page 96

Operating Guide
MENU > Settings > Application
MENU > Settings > Tank temperature
Cont. T control
Circuit
All
The desired DHW heating / charging temperature can be lowered when the
DHW heating / charging procedure has elapsed.
* See Appendix "Parameter ID overview"
OFF: The desired heating / charging temperature is lowered
to 10 °C. Typically, the DHW is circulated through the
DHW tank.
ON: The desired heating / charging temperature is lowered
to the desired DHW temperature. Typically, the DHW
is circulated through the heat exchanger in order to
compensate for the heat loss in the DHW circulation
pipe.
MENU > Settings > Application
MENU > Settings > Tank temperature
Circ. P priority
Circuit
All
Choose whether the DHW circulation pump should be ON during DHW
heating.
* See Appendix "Parameter ID overview"
OFF:
The DHW circulation pump is switched OFF during DHW
heating.
ON: The DHW circulation pump is not switched OFF during
DHW heating.
MENU > Settings > Application
P charge delay (Charging pump, delayed start)
Circuit
All
Conditions for switching the DHW heating / charging pump ON at DHW
heating / charging demand.
Correct setting can avoid discharging.
* See Appendix "Parameter ID overview"
OFF: DHW heating / charging pump is switched ON when
DHW heating / charging temperature is OK.
0: DHW heating / charging pump is switched ON.
Value: DHW heating / charging pump is switched ON after the
set number of minutes.
96 DEN-SMT/DK
ECL Comfort 210 / 310, application A247 / A347
1x054
Setting range Factory setting
*
1x055
Setting range Factory setting
*
1x059
Setting range Factory setting
*
*
When the 'Circ. P priority' is set to OFF, the schedule for the DHW
circulation pump is overruled.
*
When the setting "OFF" is selected, the temperature sensor for DHW
heating / charging must be placed in the heat-exchanger.
*
VI.LG.S3.02
Danfoss District Energy