Sending - Muratec F-98 Operating Instructions Manual

Getting started
Note: Whether you decide to send your documents from memory or through the
document feeder, you can override that choice one transmission at a time by
pressing
MEMORY TRANSMIT
ing the communication, your fax will return to the default setting.
Note: Although it's probably best to transmit from memory, please note there are
some documents that use up memory more quickly than others. They include
documents with many pages and documents with a lot of dark areas, since
darker pages create more data for your fax machine to "remember" and
send. When the machine's memory supply is full, it can transmit only
through the document feeder.
To make memory transmission the default:
1
Press , , 1, 3,
PROGRAM J ENTER
Memory Tx:
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
appears. In this example, we've chosen Off.
Memory Tx:
Program/Enter
3
Press to save the setting.
ENTER

Sending

Here's how to fax a document:
1
Insert the document.
When a document is in the feeder, the
and the amount of memory available:
Document Ready
A4 Memory100%
2
Adjust resolution and contrast if necessary. If these are
Otherwise, press
RESOLUTION
to change the contrast.
3
"Toggle" (switch on or off) memory transmission if necessary.
If you want to use your default setting, skip to step 4.
Otherwise, press
MEMORY TRANSMIT
1.14
before you send your document. After complet-
.
On
once or twice until your chosen mode
PROGRAM
Off
shows the scanning width setting
LCD
, skip to step 3.
OK
to change the resolution and/or press
once to "toggle" memory transmission.
4
Enter the fax number.
(In fax terms, you're calling the remote fax, on its remote fax number.)
Press Start
919725552009_
As you can see, you also enter any access codes (such as a 9 for "dialing out"
from an office telephone system, or 1 for long-distance) along with the num-
ber, just as you would for a regular phone call.
5
Press
START
6
Now, everything is up to the machines — yours and the one you're dialing.
• If you have set the fax to transmit from memory, your machine will first
scan the document into memory, then dial the other fax. When it makes
contact, your machine transmits the stored document from memory.
• If the fax is set for non-memory transmission, your machine simply dials
the other fax. When it makes contact, your machine feeds the document
through, scanning and transmitting it as it goes.
Note: The more "stuff" (or black coverage, to use the fax term) your machine
"sees" on a page, the more slowly the page will feed through as the fax
scans it — especially when you transmit in non-memory mode. Even
if the page itself is relatively clean, sending it in grayscale mode or
certain resolution settings makes your machine "see" more "stuff."
The same is true if you set the contrast to Dark.
Note: What if the call fails for some reason? See "If the call doesn't go
through — redialing," next page.
Important: If you wish to cancel a transmission while it is in progress, you
7
At the end of the operation, your fax machine beeps and displays:
972-555-2009
** Complete **
Important: Whenever you transmit, whether this way or in the numerous
CONTRAST
.
will need to use the Review Commands function. See "An intro-
duction to Review Commands," page 1.16.
ways we'll describe throughout this manual, what actually
appears on the top line of the display will depend upon informa-
tion stored in the remote fax. The line may even be blank.