Subaru EX13 Service Manual page 94

Step Parts to remove
Throttle body,
Insulator
10
Renarks and procedures
(1) Disconnect the fuel pump pulse line from the throttle body .
(2) Leaving the wire harness plugged into the throttle body, disconnect
the EFI wire harness from the engine .
(3) Remove the harness ground (black) from the top of the crankcase .
(4) Disconnect the engine temperature sensor (yellow) from the back
of the throttle bracket .
(5) Disconnect the low oil sensor lead (orange) and the power
generation lead (red) from the harness .
(6) Once the wire harness is completely free from the engine, remove
the throttle body with wire harness from the cylinder head .
Remove the insulator .
M5 TAPPING
SCREW
M6 × 12 BOLT
WIRE HARNESS
GASKET
GASKET
INSULATOR
- 5 -
Parts Fasteners
M5 tapping screw
+ screwdriver
10mm box spanner
M6 × 12mm : 2 pcs
THROTTLE BODY
FUEL PUMP
PULSE LINE