Subaru EX13 Service Manual page 23

Step Parts to remove
Ignition coil Remove the spark plug cap from the spark plug and
12
Starting pulley Remove the starting pulley from the flywheel.
Fit a box wrench or a socket wrench on the flywheel nut
1) Do not insert a screwdriver or other object between the
13
Flywheel Remove the flywheel from the crankshaft. Leave the nut
14
Fig. 5-10
Remarks and procedues
remove the ignition coil from the crankcase.
and loosen the nut by knocking the wrench sharply with a
hammer. (See Fig. 5-10)
NOTE:
flywheel blades, otherwise the risk of damaging the
blades might be occured.
2) Knock the wrench with a hammer in a counter
clockwise direction.
3) The fan of the Model EX21 engine is made of
synthetic resin. Take the utmost care when handling it.
temporarily to prevent the flywheel from dropping out. Fit
the flywheel puller as shown in Figure 5-11 and remove
the flywheel from the crankshaft by rotating the bolt at the
center in a clockwise direction.
(Knock the center bolt with a hammer sometimes)
FLYWHEEL
Fig. 5-9
- 20 -
M14 NUT : 1 pc. (EX13,17,21)
M18 NUT : 1 pc. (EX27)
STARTING
PULLEY
GROMMET
(EX13,17,21 only)
Fasteners
10 mm box spanner
M6 × 25mm : 2 pcs.
19 (24) mm box spanner or
socket wrench M14 nut
(Models EX13, 17 and 21)
M18 nut (Model EX27)
Flywheel puller
ATTACH NUT
TEMPORARILY
FLYWHEEL PULLER
Fig. 5-11
M6 x 25 BOLT and
WASHER : 2 pcs.