Subaru EX13 Service Manual page 45

(24) AIR CLEANER BASE
Insert the breather pipe into the rocker cover
and then mount the air cleaner base.
M6 flange nut : 2 pcs.
M6 x 20 mm flange bolt : 1 pc.
Tightening torque
-
6.0 8.0 N ・ m
( -
60 80 kgf ・ cm)
(4.3 - 5.8 ft・ lb.)
Governor system adjustment method
■
The governor unit is a centrifugal flyweight type and is installed on the governor gear.
Since it automatically adjusts the throttle valve of the carburetor by means of a link mechanism, it is possible to
maintain a constant engine speed, even with load variations.
(1) Turn the speed control lever to the full speed position, making sure that the carburetor throttle valve is fully
open.
(2) Hold the top of the governor shaft with the plier and turning it clockwise as far as it will go. Tighten the bolt on
the governor lever.
Tightening torque
-
8.0 10.0 N ・ m
( -
80 100 kgf ・ cm)
(5.8 - 7.2 ft・ lb.)
M6 x 20
FLANGE BOLT : 1 pc.
GOVERNOR
SHAFT
- 42 -
AIR CLEANER BASE
BREATHER
PIPE M6 FLANGE
NUT : 2 pcs.
Fig. 5-57
GOVERNOR
LEVER
GOVERNOR ROD
and ROD SPRING
GOVERNOR
SPRING
Fig. 5-58