Subaru EX13D Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Subaru Manuals
  4. Engine
  5. EX13D
  6. Instructions for use manual

Subaru EX13D Instructions For Use Manual

Ex series ohc gasoline engines
Hide thumbs

Advertisement

Table of Contents

EX series
PL
KR
2ZZ9990213
OHC Gasoline Engines

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX13D and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Subaru EX13D

Summary of Contents for Subaru EX13D

  • Page 1 EX series 2ZZ9990213 OHC Gasoline Engines...

  • Page 5: Table Of Contents

    FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and effi cient use of this product. Keep this owner’s manual at hand, so that you can refer to it at any time.

  • Page 6: Safety Precautions

    1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. CAUTION “CAUTION”...
  • Page 7 ■ Do not touch the spark plug and ignition cable when starting and operating the engine. ■ Never make adjustments on the machinery while it is connected to the engine, without fi rst removing the ignition cable from the spark plug. Turning the crankshaft by hand during adjusting or cleaning might start the engine, and cause serious injury to the operator.

  • Page 8: Components

    SYMBOLS Shutt off fuel valve Read manual. when the engine is not in use. Check for leakage Stay clear of the hot surface. from hose and fittings. Exhaust gas is poisonous. Fire, open flame and smoking Do not operate in an unventilated prohibited.

  • Page 9: Pre-Operation Checks

    3. PRE-OPERATION CHECKS Explanation of Fig. -① NOTE ❶ Maximum Fuel level Engine shipped from our factory is without oil. Before starting engine, fi ll with oil. Do not over-fi ll. ■ Do not fi ll above the top of the fuel fi lter screen (marked ❶), or the fuel may overfl...

  • Page 10: Belt Pulley Installation Onto Keyway-Type Crankshaft

    3. KEY SWITCH CABLE 5. WIRING DIAGRAM (RECOIL STARTER MODELS) If a remote key switch is used, select wires of proper gauge to connect it and magnetic switch of the engine. Spark plug Black Wire gauge Cable length Cable dia. To LED Lamp (BS)
  • Page 11 ■ Metric keyway-type crankshaft Key Location When using the belt pulley with the extended boss on both Washer; Use the washer (material; SS41P) with the thickness side as shown in the illustration, put the spacer so that the described below; key stays in the keyway portion of the crankshaft.

  • Page 12: Operating Your Engine

    Pulley fi tting onto PTO shoulder FOR ELECTRIC STARTER MODELS. For proper pulley fi tting onto PTO shoulder, make round chamfer at pulley corner. Insert the key into the key slot and set it at the “ I ” (ON) Sharp edge of pulley corner strikes PTO shoulder.

  • Page 13: Maintenance

    7. MAINTENANCE (See Fig. 1. DAILY INSPECTION (See Fig. -①) (2) Check electrode gap. The gap should be 0.6 mm to 0.7mm. Adjust the gap, if necessary, by carefully bending the side Before running the engine, check the following service items. electrode.
  • Page 14 ■ For EX27 urethane foam, remove it from the non-woven 5. CLEANING FUEL CUP (See Fig. -⑤) cloth element and clean it via the method described in WARNING Flame Prohibited B above. (See Fig. -⑦-❶) ■ Wash the element in kerosene and drain off the kerosene. (1) Inspect fuel cup for water and dirt.

  • Page 15: Preparations For Storage

    8. PREPARATIONS FOR STORAGE 1. DISCHARGE FUEL (See Fig. -①) NOTE WARNING Flame Prohibited Instead of washing oil (kerosene), it is possible to wash the urethane foam element in a solution of mild detergent and If you do not use the engine more than 1 month, discharge fuel warm water.

  • Page 16: Oil Sensor Instructions (Optional)

    9. OIL SENSOR INSTRUCTIONS 10. EASY TROUBLESHOOTING (OPTIONAL) 1. FUNCTION OF OIL SENSOR WHEN ENGINE WILL NOT START : The engine will stop automatically when the oil level falls below Perform the following checks before you take the engine to the safety limit.

  • Page 17: Specifications

    11. SPECIFICATIONS MODEL EX13D EX17D EX21D EX27D Type Air-cooled, 4-cycle single cylinder, overhead camshaft, gasoline engine Displacement mL (cc) Continuous Output kW/rpm 2.2/3600 2.9/3600 3.7/3600 5.1/3600 (HP/rpm) (3.0/3600) (4.0/3600) (5.0/3600) (7.0/3600) Maximum Output kW/rpm 3.2/4000 4.2/4000 5.1/4000 6.6/4000 (HP/rpm) (4.3/4000) (5.7/4000)
  • Page 19 [appendix] Instructions for treatment as waste When disposing this product ,make sure that the fuel and oil should be drained from the engine ,and submit to local regulations. [Annexe] Instructions pour le traitement des déchets Quand ce produit doit être mis au rebut, s'assurer que le carburant et l’huile ont été vidangés correctement à...
  • Page 20 ISSUE EMD-EU7413 PRINTED IN JAPAN August 2012...

This manual is also suitable for:

Ex17dEx21dEx35dEx40dEx27dEx30d ... Show all

Table of Contents