Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Subaru EH72D
Summary of Contents for Subaru EH72D
- Page 1 EH72D EH63D/64D/65D 2ZZ9020118 海外一般(排対)
-
Page 2: Air Index
WARNING : The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines/ generators complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A. -
Page 3: Federal Emissions Component Defect Warranty
FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE – This emission warranty is applicable in all States, except the state of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein "engine") has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S. - Page 4 *The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine or equipment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non- authorized parts.
-
Page 5: California Emission Control Warranty Statement
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein "FUJI") are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, the engine must be designed, built and equipped to meet the State's stringent anti-smog standards. -
Page 6: Limited Warranty
LIMITED WARRANTY on Emission Control Systems - California Only - FUJI warrants to the owner of the 2005 and later engine that the engine 1) has been designed, built and equipped so as to conform at the time of manufacture with the applicable regulations of the California Air Resources Board, and (2) is free from defects in materials and workmanship that could cause it to fail to conform with those regulations as may be applicable in the terms and conditions stated below. - Page 7 (4) repairs performed outside of the authorized warranty service dealers (5) use of parts which are not authorized by FUJI. 2. Add-on or modified parts This warranty does not cover any part that malfunctions, fails or is damaged due to alterations by changing, adding to or removing parts from the engine.
- Page 8 (4) Exhaust manifold, if applicable (5) Miscellaneous Items Used in Above Systems (i) Electronic controls, if applicable (ii) Hoses, belts, connectors, and assemblies. (iii) Filter lock assy (gaseous fuel, if applicable) I. MAINTENANCE STATEMENTS It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2005 and later Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended.
- Page 9 FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Engine Emission label Engine serial No. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product.
-
Page 10: Table Of Contents
CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3. - Page 11 SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. Plus ; On (Run) positive polarity Off (Stop) Battery Engine start (Elec- Engine oil...
-
Page 12: Safety Precautions
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. EXHAUST PRECAUTIONS Never inhale exhaust gas. ■ It contains carbon monoxide, a color- less, odorless and extremely danger- ous gas which can cause uncon- sciousness or death. Never operate the engine indoors or ■... - Page 13 PROTECTIVE COVER Place the protective covers over ■ the rotating parts. If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. Be careful of hot parts. ■...
- Page 14 Drain the fuel when transporting ■ the engine. Do not move the engine while in ■ operation when it has been removed from the equipment. Keep the unit dry (do not operate it in ■ rainy conditions). PRE-OPERATION CHECKS. Carefully check fuel hoses and ■...
-
Page 15: Components
2. COMPONENTS Air cleaner cover Speed control lever Key switch Control box Choke knob Spark plug cap Fuel pump Blower housing Fuel filter Oil cooler (EH72 only) Oil filler cap Carburetor Hook Spark plug cap Governor lever Engine emission label Voltage regulator Oil filter... -
Page 16: Pre-Operation Checks
3. PRE-OPERATION CHECKS STD-type Option CHECK ENGINE OIL (DAILY) gauge Before checking or refilling engine oil, be sure the engine is not running and is located on a stable, level surface. If the oil level is below the lower level ■... - Page 17 CHECK FUEL (EH63/64/65) WARNING Fuel pump Do not refuel while smoking, near an open flame or other potential hazards. The fuel tank shall be provided sepa- ■ rately, because the engine is not equipped with a fuel tank. A fuel valve and fuel filter should be Fuel inlet connected between the fuel tank and fuel pump.
-
Page 18: Battery Installation
4. BATTERY INSTALLATION For electric starter operation, proper electric wiring arrangements are needed before normal engine operation. PARTS NEEDED Use a battery rated 12V-30AH ■ (EH63/64/65), 12V-36AH (EH72) or larger. Use a proper cable and ground wire ■ to connect battery and key switch and electric starter. -
Page 19: Wiring Diagram
WIRING Connect positive terminal of elec- ■ tric starter and positive terminal of the battery with battery cable. Ground negative terminal of the ■ battery to the body of engine or machine with ground wire. Cable NOTE Electric starter Tighten bolts and nuts on terminals Battery terminal securely so they will not be loosened... -
Page 20: Operating Your Engine
5. OPERATING YOUR ENGINE NOTE Following operating method is for the STD type speed control lever. CHOKE KNOB As to the fixed type speed control lever (exp. Generator spec.), do not move it otherwise the genera- tor component such as voltage regulator may be damaged. - Page 21 RUNNING CHOKE KNOB SPEED CONTROL LEVER OPEN After starting the engine, gradu- After the engine starts, set the ■ ally open choke by pushing the speed control lever at the low choke knob and finally keep it speed position and warm it up fully opened.
-
Page 22: Stopping Engine
STOPPING SPEED CONTROL LEVER FUEL VALVE Close the fuel valve. Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. ELECTRIC STARTER STOPPING ENGINE WITH THE FUEL VALVE Close the fuel valve while the engine is running and wait until the... -
Page 23: Easy Troubleshooting
6. EASY TROUBLESHOOTING WHEN ENGINE WILL NOT START: Perform the following checks before you take the engine to your Robin dealer. ■ If you still have trouble after completing the checks, take the engine to your ■ nearest Robin dealer. Is there enough compression? If the spark plug is loose, tighten it. - Page 24 Is your battery well charged ? Check the battery, it may be discharged and unable to operate the electric starter. Consult your nearest dealer or service shop. − 13−...
-
Page 25: Spark Arrester (Optional)
7. SPARK ARRESTER (OPTIONAL) In a dry or wooded area, it is recommendable to use the product with a spark arrester. Some areas require the use of a spark arrester. Please check your local laws and regulations before operating your product. The spark arrester must be cleaned regularly to keep it functioning as designed. -
Page 26: Maintenance Schedule
8. MAINTENANCE SCHEDULE MAINTENANCE, REPLACEMENT, OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NONROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. DAILY INSPECTION Before running the engine, check the following service items. Enough gasoline Excessive vibration,noise Clean air cleaner element Safe surroundings Enough clean engine oil Leakage of gasoline and engine oil... - Page 27 Periodic Maintenance Schedule table Every 8 Every Every Every Every Maintenance Items hours 1000 hours hours hours (Daily) hours Clean engine and check bolts and nuts ● (Daily) Check and refill engine oil (Refill daily to upper level) ● ● Change engine oil (*Note 1) (Every 100 hours) ●...
-
Page 28: How-To" Maintenance
9. "HOW-TO" MAINTENANCE INSPECTING THE SPARK PLUG Clean off carbon deposits on the ■ spark plug electrode using a plug cleaner or wire brush. Check electrode gap. ■ 0.7 to 0.8 mm Adjust gap to : (0.03 in) 0.7mm to 0.8mm (0.03 inches) Use a proper spark plug : ■... - Page 29 (EH63/64/65) ENGINE OIL FILTER REPLACEMENT Initial engine oil filter replacement ■ should be performed after 20 hours of operation. Thereafter replace the engine oil filter every 200 hours. Oil filter When installing a new oil filter, apply ■ oil to O-ring, attach the oil filter in position and tighten 2/3 turns by (EH72) hand or with wrench after touching...
-
Page 30: Checking Battery
Paper element ■ Clean by tapping gently to remove dirt and blow off dust. Never use oil. Clean or replace the paper element every 50 hours of operation, and replace element set every 200 hours or once a year. Clean and replace air cleaner elements more often when operating in dusty environments. - Page 31 HIGH ALTITUDE ENGINE OPERATION Please have an authorized Robin America service dealer modify this engine ■ if it is to be run continuously above 5,000 feet (1,500 meters). Failure to do so, may result in poor engine performance, spark plug fouling, hard starting, and increased emissions.
-
Page 32: Preparations For Storage
10. PREPARATIONS FOR STORAGE DISCHARGE FUEL SCREW for DRAIN (NO SMOKING !) WARNING Take extreme caution when drain- ing gasoline. It is flammable. Drain fuel from fuel tanks, carburetor and fuel line. ENGINE OIL Change the engine oil with fresh oil. ■... -
Page 33: Specifications
11. SPECIFICATIONS MODEL EH63D EH64D EH65D EH72D Air-Cooled, 4-Stroke, V-Twin Cylinder, Horizontal P.T.O. shaft, Type OHV Gasoline Engine 2-84 x 65 Bore x stroke mm(in) 2-80 x 65 (3.15 x 2.56) (3.31 x 2.56) Displacement cm (cu. in) 653 (39.8) 720 (43.9) - Page 34 ISSUE EMD-EU2133 PRINTED IN JAPAN June 2005 CE-...