Table of Contents
Advertisement
OWNER'S
INFORMATION
The appliance area must always be kept clear and free
from combustible materials, gasoline and other fl ammable
vapors and liquids.
Inspect the vent terminal outdoors regularly to make sure
that snow, trees, bushes, leaves, or other objects do not
obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
WARNING
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —see instructions
next page.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life. Should the batteries
loose power, the control may be operated by manually
turning the control knob at the valve or by turning off the
valve at the switch.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a Velcro tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA alkaline batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the Velcro tab.
Using Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further on
in this manual for the installation.
8
Owner's Information
Locating Lighting, Operation and Rating
Information Card
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION PLATE WHILE THE FIREPLACE IS STILL
HOT! Let the fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is located
on a card under the burner. To access the card, remove the
fret or access panel, grab the card and take it out to read it.
There is important information on both sides of the plate.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance's serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
Operating Your Fireplace
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
Thermostatic Remote
Control
The manual On/Off switch must be ON for the fi replace to
function. It can be used to shut off the fi replace in case of
emergency—see next sub-section.
The Thermostatic Remote Control can be programmed to
function automatically—see pages 10–14.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
WARNING
WARNING
!
Wall Switch
Manual On/Off Switch
(optional)
ON
OFF
Hide quick links:
Advertisement
Table of Contents
