Before Turning Gas Supply On; Before Lighting; Operation - Fire Sense PH01-S Instruction Manual & Parts List

C. Spoon several drops (or use squirt bottle) of the solution onto gas
hose connection and pilot connection.
D. Inspect the connections and look for bubbles.
E. If no bubbles appear, the connection is safe.
F. If bubbles appear, there is a leak. Close the propane tank valve and loosen
and re-tighten this connection.
G. Check for leaks again.
H. If bubbles still appear, close the propane tank valve and call the gas
supplier. DO NOT attempt to use the heater.
WARNING:
and understand all precautions. Failure to do so can result in serious
personal injury, death or property damage.

Before Turning Gas Supply ON.

Your heater was designed and approved for OUTDOOR USE ONLY. DO
NOT use it inside a building or any other enclosed area.
Make sure surrounding areas are free of combustible materials such as
gasoline and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Heater should be thoroughly inspected before each use. Have a qualified
service person inspect the heater at least annually. If relighting a hot
heater, always wait at least 5 minutes.
DO NOT attempt to operate heater until you have read

Before Lighting

- 13 -
ASSEMBLY

OPERATION