Appendix; Questions And Answers - Siemens Gigaset A 200 Manual

Appendix

Questions and Answers

If you have questions about your phone, look under
www.my-siemens.de/kundenservice where we can be contacted around the clock. In
addition we have included here the most frequently asked questions and their answers.
What happens if ...
... the display is blank?
... the handset doesn't react to
a key being pressed?
... all the icons are flashing in
the display and there is no con-
nection with the base station?
... (where multiple handsets
are in use) the handset in the
base station is not charging?
... the handset does not ring?
... the caller can't hear me?
... despite CLIP, the caller's
number is not displayed?
... entries in the caller list don't
show time or date?
... I can't hear the ringer or dial-
ling tone?
... I can hear an error tone
(descending tone sequence)
when keying in?
Possible cause
The handset is not
switched on.
The batteries are empty.
The keypad protection is acti-
vated.
The handset is outside the
range of the base station.
The handset has not been reg-
istered.
The base station is not
switched on.
The cable has not been cor-
rectly placed in the bottom of
the base station.
Charging in the base station
only takes place when a phone
call is not being made at the
same time.
The ringer is switched off.
The ringer volume has been
set to "0".
Call divert has been set on
AUTOMATIC.
INT
You've pressed the
a result the handset has been
"muted".
Sending the phone number
(CLI) has not been enabled.
Date and time have not been
set.
You have changed the phone
cable on your Gigaset.
The task has been unsuccessful
or the entry is faulty.
Possible solution
Press the end call key
approx. 5 secs.
Charge or replace batteries
(page 7).
Press the hash key
approx. 2 secs (page 8).
Reduce distance between
handset and base station.
Register handset (page 33).
Check power cable plug on
base station (page 6).
Check cable placement
(page 6)
Use additional charger unit.
Switch on (page 40) ringer.
Increase ringer volume
(page 39).
Deactivate call divert
(page 20).
key. As Activate the microphone again
with MENU, BACK, OK
(page 16).
The caller should request the
network operator to enable the
transfer of his or her phone
number.
Set date and time (page 13)
When buying a cable at a spe-
cialist shop make sure it has the
correct plugs (page 47).
Repeat the process; watch the
display when doing so and if
necessary check with the oper-
ating manual.
Appendix
a
for
R
for
45