Base Station Settings; Changing The System-Pin; Return Base Station To Factory (Default) Settings - Siemens Gigaset A 200 Manual

Base station settings

Base station settings
All base station settings are made via a registered Gigaset A 2 handset.

Changing the system-PIN

To protect the system settings from unauthorised access you should change the system-
PIN (factory setting: 0000) to a PIN that only you know.
[_______________]
MENU
[__________] [______________________________________________] [__________]
BASE SET
[__________] [______________________________________________] [__________]
SYSTEM PIN
[______]
OK
[______]
OK
[______]
OK

Return base station to factory (default) settings

A reset does not alter the system PIN; handsets remain registered.
[_______________]
MENU
[__________] [______________________________________________] [__________]
BASE SET
[__________] [______________________________________________] [__________]
BASE RESET
[______]
OK
[______________________________________________] [__________]
RESET ?
Factory settings of base station
System PIN
Barge in
Pause after R key
Pause after line seizure
Flash time
Dialling procedure
1
Speed dial
42
Press display key to open menu.
Select and confirm.
OK
Select and confirm.
OK
Enter the currently valid system PIN (4 digits) and
confirm. For security reasons the entry is shown as
four stars ( **** ).
Enter new PIN (4 digits) and confirm.
Repeat new system PIN and confirm.
Long press (return to idle status).
Press display key to open menu.
Select and confirm.
OK
Select and confirm.
OK
Enter system PIN and confirm.
Confirm safety check.
OK
Default settings
0000
deactivated
800 ms
3 s
120 ms
MFV
Mailbox without
number
Status after Description
reset
unaffected page 42
deactivated page 37
800 ms page 44
3 s page 44
120 ms page 43
MFV page 43
Mailbox without page 23
number