Table of Contents
Advertisement
Appendix
Care
¤
Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
¤
Immediately switch the handset off
and remove the batteries.
¤
Allow the liquid to drain from the hand-
set.
¤
Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave or convection oven,
etc.).
¤
Do not switch on the handset again
until it is completely dry.
Once fully dried, you should be able to use
it again normally.
!
Troubleshooting
If you have any questions about using
your phone, visit us anytime at
www.gigaset.com/customercare. The
table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the End call key
2. The battery is empty.
¥
Charge the battery or replace it
(page 11).
The handset does not respond to a key
press.
The keypad lock is activated.
¥
Press and hold the pound key
(page 18).
is flashing on the display.
Base
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base.
2. The base station is not switched on.
¥
Check the base station power cord
(page 11).
Handset does not ring.
The ringer is switched off.
¥
Activate the ringer (page 32).
You cannot hear a ringer/dialing tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections.
Correct phone jack assignment
4
3
5
2
6
1
The incoming call number is not displayed
although CID (page 17) is set.
Caller ID is not enabled.
¥
The user must ask his or her network
provider to enable caller ID (CID).
Appendix
a
.
#
1 unused
2 unused
3 a
4 b
5 unused
6 unused
35
Advertisement
Table of Contents
