Table of Contents
Advertisement
3. SORT OR STAPLE COPYING (Cont.)
4 4 4 4 4
Select the desired exposure, reproduction
ratio, etc. as required.
5 5 5 5 5
Press the PRINT
G The originals placed on the original feed
tray will automatically be fed in one by
one.
G If the stapling mode is selected, all the
sets of copies will automatically be stapled
after copying is finished.
G If the copier stops during the sort or
stapling mode and displays:
Remove paper from
sorter bins
remove all the copies from the sorter and
press the PRINT
continue. In this case, stapling is not
possible.
6 6 6 6 6
When the original was set on the glass,
after the copying of the first original (last
page) finishes, place the next original
and press the PRINT
7 7 7 7 7
Repeat step 6 until all the originals finish
being copied.
G Refer to the table in step 2 on page 109
for the maximum number of originals that
can be copied.
8 8 8 8 8
When the MG-2010/MG-2012 is used,
pressing the STAPLE
sorter will cause the copies in each bin to
be stapled automatically.
G While stapling is in progress, if you press
the STAPLE
stop. Pressing the key again will resume
stapling.
G The STAPLE
only when stapling is possible. However,
if the maximum number of copies that
can be stapled is exceeded, the STAPLE
key lamp goes out, alerting the
operator that stapling is not possible.
Note: During stapling, do not open the stapler
door. Doing so may cause a staple
jam.
110
key.
key again to
key.
key on the
key again, stapling will
key lamp comes on
5
Advertisement
Table of Contents
