Mitsubishi Heavy Industries FDC112KXEN6 Technical Manual page 275

7) Press SET button. (Fixing of the upperlimit position)
The upper limit position is fixed and the setting position is displayed for two seconds.Then proceed to lower limit position
selection display.
[EXAMPLE]
(displayed for two seconds)
(shows current setting)
8) Press or button. (Selection of lower limitposition)
Select the lower limit position of louver.
"position 1" is the most horizontal, and "position 6 " is the most downwards.
"position --" is to return to the factory setting. If you need to change the setting to the default setting, use "position --".
(the most horizontal)
(the most downwards)
(return to the default setting)
9) Press SET button. (Fixing of the upper limit position)
Upper limit position and lower limit position are fixed, and the set posi-
tions are displayed for two seconds, then setting is completed.
• After the setting is completed, the louver which was set moves from the
original position to the lower limit position, and goes back to the origi-
nal position again. (This operation is not performed if the indoor unit
and/or indoor unit fan is in operation.)
[EXAMPLE]
(displayed for two seconds)
10) Press 1 ON/OFF button.
Louver adjusting mode ends and returns to the original display.
Caution
If the upper limit position number and the lower limit position number are set to the same position, the louver is fixed
at that position auto swing does not funtion.
ATTENTON
If you press RESET button during settings, the display will return to previous display.If you press
button during settings, the mode will be ended and return to original display, and the settings that have not been
completed will become invalid.
271
- -
Upper
position
Movable
range
Lower
position