Mitsubishi Heavy Industries FDC112KXEN6 Technical Manual page 239

(ii) Bolt positions
1) Bolt positions for metal settings used for floor fixation.
• Metal fitting used for floor fixation (accessories).
Bolt positions for floor mounting hardware
Floor mounting hardware
Accessory
10 x 30 elongated hole
Use M8
Note (1) Value in ( ) indicates 71 type.
(iii) Installation of unit
1) Floor standing installation
a) Position of mounting bracket fixing bolts
Drill holes by referring to figures below.
Hole for piping
& wiring on floor
b) The methed of drilling the wall is as follows.
Indoor
¯70~86 mm
c) Level the unit using the level adjusting screw. Installation will be complrted after attaching side and front panel.
d) Exceute fixation following the directions described below.
● When fixed on the floor
rame side panel
Unit : mm
Front
Back
806(1091)
As viewed from floor side.
hen fixed on the wall
4 places
Hole for piping &
wiring on wall
hen fixed on the floor
2 places
all
Outdoor
Sleeve
Tighten the bolt for floor
fixation using a flat washer
and double nut.
Mounting platc
(Accessories)
2) Bolt positions for wall fixation
112
Bolt for wall mounting
Note (1) Be sure to use a bolt of the length for wall mouning.
● When fixed on the wall
235
- -
1150(1435)
786 (1071) 179
Elongated hole for Screw for adjusting
wall mounting levelness.
4 - 12 × 24
Use M10
30
all
all
Sealing plate
Sleeve
Tighten the bolt for wall
fixation using a flat washer
and double nut.
Unit : mm