Mitsubishi Heavy Industries FDC112KXEN6 Technical Manual page 271

(b) How to set function
1) Stop air-conditioner and press
buttons at the same time for over three seconds, and the
"FUNCTION SET
2) Press ( SET) button.
3) Make sure which do you want to set, " FUNCTION "
(remote controller function) or "I/U FUNCTION
(indoor unit function).
4) Press or button.
Selecct " FUNCTION
or "I/U FUNCTION
5) Press ( SET) button.
6) On the occasion of remote controller function selection
"DATA LOADING" (Indication with blinking)
Display is changed to "01 GRILLE
Press or button.
"No. and function"are indicated by turns on the remote
controller function table, then you can select from them.
(For example)
Press (SET) button.
The current setting of selected function is indicated.
(for example) "AUTO RUN ON"
RUN SET" is selected
Press or button.
Select the setting.
Press (SET)
"SET COMPLETE" will be indicated, and the setting
will be completed.
Then after "No. and function" indication returns, Set as
the same procedure if you want to set continuously ,and
if to finish, go to 7.
7) Press ON/OFF button.
Setting is finished.
It is possible to finish by pressing ON/OFF button on the way, but unfinished change of setting is
unavailable.
During setting, if you press
Setting is memorized in the controller and it is saved independently of power failure.
How to check the current setting
When you select from "No. and funcion" and press set button by the previous operation, the "Setting" displayed first is
the current setting.
(But, if you select "ALL UNIT
(SET) (MODE)
" will be displayed.
"
" (remote controller function)
" (indoor unit function).
SET".
Function No.
Function
If "02 AUTO
Setting
", the setting of the lowest number indoor unit is displayed.)
Operation message
Function description:
setting description:
4 )
Indoor unit selection button
On the occasion of indoor unit function selection
"DATA LOADING" (Blinking for 2 to 23 seconds to read the data)
Indication is changed to "01 AUTO FILTER CLEANING".
Go to .
[Note]
(1)
If plural indoor units are connected to a remote controller,
the indication is "I/U 000" (blinking)
number of the indoor unit connected is indicated.
(2) Press or
Select the number of the indoor unit you are to set
If you select "ALL UNIT
setting with all unites.
(3)
Press
Press or
"No. and function" are indicated by turns on the indoor unit
function table, then you can select from them.
(For example)
Press (SET) button.
The current setting of selected function is indicated.
(For example) "STANDARD"
is selected.
Press or
Select the setting.
Press (SET) button.
"SET COMPLETE" will be indicated, and the setting will be
completed.
Then after "No. and function" indication returns, set as the same
procedure if you want to set continuously , and if to finish, go to 7.
When plural indoor units are connected to a remote controller,
press the AIRCON NO. button, which allows you to go back
to the indoor unit selection screen. (example "I/U 000
(RESET) button, you return to the previous screen.
267
- -
,
Function No.
Fixing button
7 )
Finishing button
1 )
Starting button
Previous screen button
The lowest
button.
", you can set the same
(SET) button.
button.
Function No.
Function
If "02 FAN SPEED SET"
Setting
button.
")