Mitsubishi Heavy Industries FDC112KXEN6 Technical Manual page 228

(iii) Installation
1) Fasten the suspension lugs to the suspension bolts.
Air outlet
Fasten the bolts
to the front of the
slotted holes.
2) Attach the unit to the suspension lugs.
1 Slide the unit onto the suspension lugs from
the front, hanging it on the bolts.
2 Fasten the unit securely on the left and right
sides with 4 suspension bolts (M8).
3 Tighten the 2 screws (M4) on the left and right
sides.
After sliding the side panels on from the front to rear, fasten them securely with the screws.
3) IN order to make it easier for water to drain out. install the unit so that the water drain side slopes
downward.
● Left-right direction
(The figure shows the case where the
drain hose is on the right side.)
(If the connection is on the left
side, reverse the slope.)
If the slope is reversed, there is danger of water leaking out.
<If there is ceiling material>
Unit
Lug for suspension
*Fasten it securely with double nuts.
● Front-rear direction
<If there is no ceiling material>
Suspension bolts
Lug for suspension
Ceiling board
Flat washer
(accessory parts)
*Double nuts
224
- -
Suspension bolts
Nut
Flat washer
Flat washer
Unit
(accessory parts)
*Double nuts
Lug for
suspension
Screw for
suspension
lug (M4)
Suspension bolts
(M8)