Installing The Nxa-Base/1 Below An Nxt-Cv10 Panel - AMX NXT-CV10 Operation/Reference Manual

CV10 Touch Panel Accessories
NXT-BP Battery
FRONT
FIG. 29 Battery installation
3.
Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector Port.

Installing the NXA-BASE/1 below an NXT-CV10 Panel

1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2.
Place the battery base (with battery) onto a flat/level surface.
3.
Turn the battery locking slider (FIG. 30) to one side until the locking mechanism is horizontal to the base
(going left to right) and the rear battery latch is pointing directly outward (away from the LCD).
Panel Interface
connector (male)
Front
Securing
pegs (2)
FIG. 30 NXA-BASE/1 showing Panel Interface and connector locations
4.
Carefully angle the NXT-CV10 panel over the front alignment pegs (FIG. 31). The pegs assist in both
aligning and securing the panel to the base (the locking mechanism secures the base to panel when done).
28
Alignment
pegs (2)
Back
Battery
Connector
Battery
Connector
Port
Battery
locking
mechanism
Battery
locking slider
(Battery not shown
for illustration purposes)
Insert holes for
NXT-CV10 feet
10" Modero Touch Panels