AMX NXT-CV10 Operation/Reference Manual page 33

Outer Housing
FIG. 19 Location of the Tilt Bracket screws
6.
Locate the two screw holes at either sides of the front speaker grill and then use a grounded
Phillips-head screwdriver to remove the two Tilt Bracket Screws (FIG. 19). This procedure both loosens
the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets) and provides greater flexibility
for the removal of the outer housing. Without this step, the Hinge brackets (FIG. 19) present an obstacle
to the removal of the outer housing and restrict access to the circuit board.
7.
Tilt the LCD panel back up to gain better access to the Tilt Bracket cover plate.
8.
In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and then out
(away from the LCD panel) to expose the internal circuit board (FIG. 20).
Outer Housing
FIG. 20 Removal of the outer housing and wireless card location
10" Modero Touch Panels
Hinge Brackets (2)
Base
CV10 Touch Panel Accessories
Tilt Bracket/Speaker assembly
Tilt Bracket Screws (2)
These two screws must
first be removed before
being able to remove
the outer housing.
Base
Tilt Bracket cover plate
(must be removed first)
Outer housing
installation holes
(located on front panel)
21