Table of Contents
Advertisement
• A maximum of 55 messages, including an outgoing message, alternative message, voice memos, Fax/Tel message
and forwarding message, with a total maximum recording time of 10 minutes can be recorded. You can set a
maximum recording time of 120 seconds for each telephone message (see below).
• If you have any new telephone messages, the TAM LED blinks and the number of messages appears on the LCD.
• The day and time when the telephone message was recorded, the number of telephone messages and the number of
the message being played (ICM No.) are displayed whenever a message is played.
When TAM MODE is set and a call is received, the fax will respond as described below.
1
The fax will ring 2 or 5 times, when TOLL SAVER is set to ON, depending on whether there are
any telephone messages (see p. 42).
When TOLL SAVER is set to OFF, you can specify the number of times the fax will ring.
2
The outgoing message is played to the other party.
3
If the other party sends a fax after they leave a message, or if the call is a fax call, the fax is
received automatically.
When the fax is set to MANUAL MODE and MAN/AUTO SWITCH has been set to OFF (see p. 51), TAM MODE will
be activated if the fax rings 15 times and the call is not answered (only when an outgoing message has been recorded).
When the call is disconnected, the fax returns to MANUAL MODE.
Setting the recording time for a telephone message
1
Press [Function], then press [Start/Copy].
2
Use [
] or [
] to select TAM SETTINGS, then press [Start/Copy]
twice.
3
Use [
] or [
] to select the recording time, then press [Start/Copy].
4
Press [Stop].
Setting ends and the fax returns to standby mode.
When the recording time is set to 0, the alternative outgoing message is played. If an alternative outgoing message has
not been recorded, the outgoing message is played. In this case, there will be no beep after the message is played and the
caller will not be able to leave a message.
7
30 SECONDS
41
Advertisement
Table of Contents
