Canon FAX-B840 User Manual page 65

Message
CHECK DOCUMENT
CHECK PAPER SIZE
CHECK PRINTER
CLEAR PAPER JAM
DATA ERROR
DOC. TOO LONG
ECM RX
Cause
The document is not set in the document
tray.
The size of the paper in the multi-purpose
tray and that specified in the PAPER
SIZE setting are different.
There may be an obstruction that is not
allowing the cartridge holder mechanism
to move.
The BJ cartridge may be defective.
The waste ink tank (which holds the ink
used for print head cleaning) may be full.
During printing, the BJ cartridge print
head may have become too hot.
There is a paper jam.
An error has occurred and all one-touch
speed dialling, coded speed dialling, and
user data have been lost.
The document is longer than 700 mm.
The fax is receiving a document using
Error Correction Mode (ECM).
Action
Set the document you are trying to
send or copy (see p. 24) and start
again.
Load the correct paper size or change
the PAPER SIZE setting (see p. 51).
Check for any obstruction (paper clip,
small object, etc.) and also that the
orange protective cap and tape are
removed from the BJ cartridge. Check
also for a paper jam and clear the jam
if necessary (see p. 55). Then press
[Stop] and start again.
Press [Stop]. Reinstall the BJ
cartridge (see p. 11) and start again.
In either case, if the error does not
clear, try unplugging the fax. Wait
several minutes, then plug it back in.
Also, try replacing the BJ cartridge
with a new one (see p. 58).
Contact your local authorised Canon
dealer or the Canon help line to have
the waste ink tank replaced
immediately.
Clear the paper jam (see p. 55).
Allow the fax to cool down. The fax
will resume printing when it has
cooled down.
Clear the paper jam (see p. 55) and
reload paper in the multi-purpose tray.
Press [Stop].
Press [Start/Copy], then re-register
the data (see Chapter 2).
Use a copier to make a reduced copy
of the document and then send the
copy.
Turn off ECM if you need to receive
quickly, or if you know your local lines
are in good condition (see ECM RX,
p. 51).
9
65