Linhai LANDBOSS LH800U-2D Service Manual page 75

CHAPTER 6 TRANSMISSION
Fig 80
38. Tighten the four screws M6 L16
to a torque of 20Nm.
Note: There is a screw fasten the lubricating oil duct
U!Fig 81(page 16).
Fig 81
39. Mount the gear consent sensor A ,
then, mount the safety ring B.
!Fig 82(page 16).
Fig 82
40. Mount the dipstick with two O-rings
as an assembly
!Fig 83(page 16).
Fig 83
41. Mount the selector lever J. Then
tighten the self-locking nut K to
a torque of 30Nm.
!Fig 84(page 16).
Fig 84
42. Tighten the electromagnet to a torque of
41~54Nm.
!Fig 85(page 16)
Fig 85
CHAPTER 6
LH800U-2D SERVICE MANUAL
TRANSMISSION. 6- 18