Linhai LANDBOSS LH800U-2D Service Manual page 69

CHAPTER 6 TRANSMISSION
Fig 46
6. Put the output drive shaft F and the
intermediate shaft E as an assembly, as
shown, then put them to their seats. !Fig
47(page 10).
Fig 47
7. clamp two engagements using
selector fork G.
!Fig 48(page 10).
Fig 48
8. Put shift drum B into their seats. then, cut
the apophysis E of selector fork G in the
notches D of shift drum B
!Fig 49(page 10).
Fig 49
9. Put the selector fork rod C in position in the
4WD right semi-housing.
!Fig 50(page 10).
Fig 50
10. Put the reverse gear shaft A into their seat.
!Fig 51(page 10).
CHAPTER 6
LH800U-2D SERVICE MANUAL
TRANSMISSION. 6- 12