Linhai LANDBOSS LH800U-2D Service Manual page 70

CHAPTER 6 TRANSMISSION
Fig 51
11. Turn the shafts manually and make
sure they run smoothly and are free
from impediments.
12. Oil all the bearings.
!Fig 52(page 11).
Fig 52
13. Grease the selector fork rod
!Fig 53(page 11).
Fig 53
14. Apply Loctite sealant 510 evenly on
the surface of the seal.
!Fig 54(page 11)
Fig 54
15. Make sure that the two centring pins A are
in their correct position.
Important: if damaged, replace the centring
pins A
!Fig 55(page 11).
Fig 55
16. Assemble the two semi-housings with
the help of a tool, as shown.
!Fig 56(page 11).
Fig 56
17. Tighten the service screws M8
(L50) to a torque of 30Nm.
!Fig 57(page 11).
CHAPTER 6
LH800U-2D SERVICE MANUAL
TRANSMISSION. 6- 13