Rear A-Arm Replacement - Linhai LANDBOSS LH800U-2D Service Manual

CHAPTER 3 CHASSIS
2014.0
5. Examine A-arm bushing. Replace if worn or tore. Discard hardware.
6. Install new A-arm assembly onto vehicle frame. Apply Loctite™ 263 to screw threads of the
A arm bolts and torque new bolts to 37~44 ft. lbs (50~60 Nm ).
DO NOT reuse old bolts. Serious injury or death could result if fasteners come loose during
operation.
7. Insert A-arm ball joint end into the bearing carrier. Torque new nuts to 22 ft. lbs (30Nm).
Install new cotter pin.
8. Attach shock to A-arm with fastener. Torque lower shock bolt to 30~33 ft. lbs (41～45Nm).
Upon A-arm installation completion, test vehicle at low speeds before putting into regular
service.

3.2 REAR A-ARM REPLACEMENT

1. Elevate and safely support the rear vehicle and remove
the rear wheel.
2. Loosen two bolts that secure the rear knuckle to the
A-arm.
3. Remove the bolt that secures the shock to the lower
A-arm.
LH800U-2D SERVICE MANUAL
CHAPTER 3 CHASSIS PAGE. 3- 3