T.38 Settings; Outgoing/Incoming E-Mail Settings - Fuji Xerox ApeosPort-V C5575 Administrator's Manual

Note
 Gateway Address
Enter the IP address of the VoIP gateway.

T.38 Settings

Configure the settings for T.38.
T.38 Transport Protocol
Select T.38 transport protocol from [TCP] or [UDP].
Note
UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
Prioritize IP Packets / Prioritize IP Packets (Ethernet 1), Prioritize IP Packets (Ethernet 2)
(Type 2 (T2) model only)
Set the priority of IP packet transmission from 0 to 255.
Note

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
Note
• If you specify a specific telephone number, specify the entire telephone number such as
"0312345678".
• When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
• The value set varies depending on your environment. Consult your network administrator.
• Set the value already specified by the network side. If you set other values, the priority does not
change.
®
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult your
network administrator.)
• The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [Prioritize IP Packets] is displayed. When two Ethernet interfaces are used,
[Prioritize IP Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] are displayed.
• When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network
Name], the specified names are displayed instead of "Ethernet1" and "Ethernet2" of [Prioritize IP
Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] respectively.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
Connectivity & Network Setup
231
5