Testing A Component - Drolet Eco-65 DP00060 Installation And Operation Manual

Eco-65 Installation and Operation Manual

8.2 Testing a Component

If you suspect that an electrical component to be defective, you can test it by following the
procedure given below.
Note that you will be able to test only components when the stove is OFF and that all the
components are no more in function. (Take note that the software versions given below are
an example only and may not reflect the actual software versions of your stove.)
Connect the stove and read the version of software included
in the control board
In order to access the test mode, press both of these control
keys simultaneously.
Each segment of each section of the display will turn on in
sequence. Push any control key to proceed.
Each complete section of the display will turn on in
sequence. Push any control key to proceed.
Each LED lights up in sequence (from « OFF » to « #6 feed
rate ». Push any control key to proceed.
Complete display and all LEDs light up simultaneously. Push
any control key to proceed.
Control Key Tests
Push the control key to proceed.
Push the control key to proceed.
Push the control key to proceed.
Push the control key to proceed.
Push the control key to proceed.
47