Fuel Feed Button; Convection Fan Speed Control; Heat Level; Reset - Drolet Eco-65 DP00060 Installation And Operation Manual

Eco-65 Installation and Operation Manual

5.1.2 Fuel Feed Button

When the "Fuel Feed" button is pushed the stove will feed pellets continuously into the burn
pot during 1 minute and then the ignition cycle will begin. The "Feed and Start" message will
appear.
Use this option when you start your stove for the first time in the season or when the stove
has run out of pellets, i.e. the hopper is empty. The auger will turn and then the stove will
start automatically an ignition cycle.
CAUTION: THIS FUNCTION CAN ONLY BE OPERATED WHEN THE STOVE IS IN "OFF"
POSITION. THE FUEL FEED SWITCH IS USED TO PRIME THE AUGER WHEN AUGER
IS EMPTY.

5.1.3 Convection Fan Speed Control

The convection fan can be adjusted to 9 predetermined speeds. By pressing on AUX, the
message FAN followed by a number between 1 to 9 will appear on the screen. It will be
possible to modify the blower speed by pressing on the + or the -. Take note that not all fan
ranges are available, but the speed of the convection blower is consistent with the requested
burn rate.

5.1.4 Heat Level

By pressing + or -, you can set the pellet feed rate and hence the heat output of your stove.
The levels of heat output will incrementally change and each LED indicates the level from 1
to 6.

5.1.5 Reset

The reset button has to be used to clear most warnings on the control panel and restart your
stove (see Section 6.6: Operating the Stove Using a Thermostat and Section 8.3: Main
Error Codes, Possible Causes and Solutions).
29