System Memory Configuration; Install Memory; Upgrade Memory - Shuttle FS51 Instruction Manual

3.3 System Memory Configuration

The FS51 mainboard has two 184-pin DIMM slots that allow you to install
from 64MB up to 2GB of system memory.
Each 184-pin DIMM (Dual In-line Memory Module) Slot can accommodate
64MB, 128MB, 256MB, 512MB, and 1GB of PC1600/PC2100/PC2700
compliant 2.5V single (1 Bank) or double (2 Bank) side 64-bit wide data
path DDR SDRAM modules.

Install Memory:

Install memory in any or all of the slots and in any combination shown as
follows.
DIMM Socket
DIMM 1
DIMM 2
Note: Maximum installed memory is 2GB.
Note: You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically. You can
check the total system memory value in the BIOS Standard CMOS
Setup menu.

Upgrade Memory:

You can easily upgrade the system memory by inserting additional DDR
SDRAM modules in available DIMM slots. The total system memory is
calculated by simply adding up the memory in all DIMM slots. After up-
grade, the new system memory value will automatically be computed and
displayed in the field " Standard CMOS Setup" of BIOS setup program.
Memory Modules
16MB, 32MB, 64MB, 128MB, 256MB, 512M ,and 1GB
184-pin 2.5V DDR SDRAM DIMM
16MB, 32MB, 64MB, 128MB, 256MB, 512M ,and 1GB
184-pin 2.5V DDR SDRAM DIMM
- 39 -
Module
Quantity
x 1
x 1