Table of Contents
Advertisement
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
Blank Screen
DPMS Supported Initial display power management signaling.
! The choice: V/H SYNC+Blank, Blank Screen, or DPMS Supported.
Switch Function
Enables you to set the System Management Interrupt (SMI) button
function in DOS.
! The choice: Disabled or Break / wake.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
! The choice: 3, 4, 5, 7, 9, 10, 11, or Auto.
HDD Off After
The IDE hard drive will spin down if it is not accessed within a speci-
fied length of time. Options are from 1 Min to 15 Min and Disable.
! The choice: Disabled, 1 Min ~ 15 Min.
Power Button Override
Pressing the power button for more than 4 seconds forces the system
to enter the Soft-Off state when the system has "hung.".
! The choice: Instant-Off or Delay 4 Sec.
Power State Resume Control
This item enables your computer to automatically restart or return to its
last operating status after power returns from a power failure.
! The choice: Always Off, Always On, Keep Pre-state.
PM Wake Up Events
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
IRQ [3-7, 9-15], NMI
When enabled, any event occurring at IRQs 3 through 15 (excluding
IRQ 8) will awaken a system, which has been powered down.
This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
This option only writes blanks to the video
buffer.
- 66 -
Advertisement
Table of Contents
