Configuration (Dmx); Dmx Personalities; Dmx Control; Loss Of Signal Setting - Chauvet COLORado 1 Solo User Manual

Configuration
(DMX)
DMX
Personalities

DMX Control

Loss Of Signal
Setting
COLORado 1 Solo User Manual Rev. 1
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the PERSONALITY main level.
2. Select the desired personality (TOUR, TR16, STD.Y, HSIC, or SSP).
·
See the DMX Values section for the highest starting address you can select for each
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN MODE main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to ADDRESS main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX DMX
Personality Address
TOUR 501
HSIC 504
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SETTING main level.
2. Enter the master access passcode as described in Passcode.
3. Select DMX ERROR.
a. Select SAVE to make the product use the last command used when the signal is lost.
b. Select BLACK to turn off the all the LEDs when the signal is lost.
DMX Personalities.
DMX DMX
Personality Address
TR16 496
SSP 504
Operation
DMX DMX
Personality Address
STD.Y 496
-15-