Table of Contents
Advertisement
Setup
3. Setup
AC Power
AC Plug
Power Linking
-6-
Each COLORado 1 Solo has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each
COLORado 1 Solo, refer to the label affixed to the product. You can also refer to the
Specifications
chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
www.chauvetprofessional.com.
·
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The COLORado 1 Solo comes with a power input cord terminated with a Seetronic Powerkon A
connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
The COLORado 1 Solo supports power linking. You can power link up to 24 products at
120 V; up to 40 at 208 V; or up to 45 at 230 V. This product comes with a power input cord.
·
To preserve the IP65 rating and the warranty of this product, Seetronic Powerkon
cables must be used.
·
Insert the attached IP65 rated plugs into the corresponding power/data connections
when not in use.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Brown
Yellow or Brass
Blue
Green/Yellow
COLORado 1 Solo User Manual Rev. 1
Technical
Screw Color
Silver
Green
Advertisement
Table of Contents
