Power Connections; Camera Settings - Bosch VEZ-400 Series Operation Manual

40 en | Connection
Number
4
5
Table 9.5: 5-pin Terminal Block Connections
9.5

Power Connections

Caution!
The camera unit accepts 24 VAC power only. Do not connect 120 V or 230 V to this camera!
!
The recommended power cable is a 2-conductor, 14-18 gauge cable, depending on the
distance.
A/W
2 A / 43 W (with heater)
9.6

Camera Settings

The camera can communicate with external switching devices such as a multiplexer or a DVR
by setting the Rotary and Dip switches. Refer to the tables below for setting the camera's ID
and selecting the protocol. The camera's Dip switches can be accessed by removing the dome
cover, and are located on a PCB attached to the camera base.
Caution!
! To prevent humidity problems, the camera's dome cover must be removed only in dry
conditions.
Caution!
When (re)mounting the dome cover to the camera base, ensure that each screw has a rubber
!
O-ring, and that the large rubber O-ring is in place on the camera base. This ensures
protection against water ingress.
2015.08 | |
Signal Color
AL1 Gray
AL0 Brown
14 AWG
(2.5 mm)
250 m
(820 ft)
Operation Manual
16AWG 18 AWG
(1.5 mm) (1.0 mm)
150 m 100 m
(492 ft) (328 ft)
AUTODOME 4000 Mini PTZ Dome
Bosch Security Systems, Inc.