Engine Installation - Toro Greensmaster TriFlex 3300 Service Manual

CAUTION
When removing engine assembly, make sure lift
or hoist can safely support 190 lbs (86 kg).
11. Attach a suitable lift or hoist to engine. Support en-
gine with lift or hoist to prevent engine from shifting or
moving.
12.Remove fasteners that secure engine to machine:
A. Remove cap screw, spacer, snubbing washer
and flange nut that secure engine support to engine
mount (Fig. 14).
B. Remove two (2) cap screws, washers and lock
nuts that secure rear engine plate to rear engine
mount (Fig. 15).
IMPORTANT: Make sure to not damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while removing the engine. Also, make
sure that hydraulic pump assembly does not shift
location during engine removal.
13.Slowly move the engine assembly away from the hy-
draulic pump assembly to allow the pump coupling to
slide out of the engine coupling flange (Fig. 16). Once
the engine has cleared the pump coupling, carefully re-
move the engine from the machine.
14.If necessary, remove engine support (item 23) from
engine.
Engine Installation (Fig. 9)
1. Make sure that all removed engine components are
correctly installed to the engine.
2. If engine support (item 23) was removed from en-
gine, secure support to engine with removed fasteners.
3. Make sure that hydraulic pump assembly is well sup-
ported to prevent it from moving during engine Installa-
tion.
CAUTION
When installing engine assembly, make sure lift
or hoist can safely support 190 lbs (86 kg).
4. Attach a suitable lift or hoist to engine.
Diesel Engine
5
4
1. Alternator stud
2. Alternator connector
3. Starter motor solenoid
FRONT
4
5
6
1. Engine
2. Engine support
3. Cap screw
FRONT
2
1. Rear engine mount
2. Cap screw (2 used)
Page 4 - - 16
1
2
Figure 13
4. Fusible link harness
5. Oil pressure switch
3
2
1
Figure 14
4. Spacer
5. Rebound washer
6. Flange nut
1
3
Figure 15
3. Washer (2 used)
4. Lock nut (2 used)
Greensmaster 3400
3
4