While Operating - Toro Greensmaster TriFlex 3300 Service Manual

While Operating

1. Sit on the seat when starting and operating the ma-
chine.
2. Before starting the engine:
A. Sit on the seat, make sure cutting units are disen-
gaged.
B. Verify that functional control lever is in neutral.
C. Verify that parking brake is applied.
D. Proceed to start engine.
E. After engine is started, release parking brake and
keep foot off traction pedal. Machine must not move.
If movement is evident, the traction pedal linkage is
adjusted incorrectly; therefore, shut engine off and
adjust traction pedal linkage until machine does not
move when traction pedal is released.
3. Do not run engine in a confined area without ade-
quate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
Greensmaster 3300/3400
4. Do not touch engine, exhaust system components or
radiator (if equipped) while engine is running or soon af-
ter it is stopped. These areas could be hot enough to
cause burns.
5. Before getting off the seat:
A. Make sure cutting units are disengaged.
B. Verify that functional control lever is in neutral.
C. Apply the parking brake.
D. Stop the engine and remove key from ignition
switch.
E. Toro recommends that anytime the machine is
parked (short or long term), the cutting units should
be lowered to the ground. This relieves pressure
from the hydraulic lift circuit and eliminates the risk of
cutting units accidentally lowering to the ground.
F. Do not park the machine on slopes unless wheels
are chocked or blocked.
Page 1 - - 3 Safety