Fusible Links - Toro Greensmaster TriFlex 3300 Service Manual

Fusible Links

The electrical system on TriFlex Greensmaster ma-
chines include a harness with three (3) fusible links for
machine circuit protection. This fusible link harness con-
nects the machine wire harness to the positive (+) bat-
tery terminal.
Greensmaster 3300 machines (gasoline engine) use
only two (2) of the harness fusible links. The fusible link
harness on Greensmaster 3300 machines is connected
to the starter solenoid (Fig. 37).
Greensmaster 3400 machines (diesel engine) use all
three (3) of the harness fusible links. The fusible link har-
ness on Greensmaster 3400 machines is connected to
the starter B+ terminal (Fig. 38). Greensmaster 3400
machines use an additional fusible link that is included
in the wire harness and connects the starter G terminal
to the engine run solenoid pull coil.
If any of these links should fail, current to the protected
circuit will cease. Refer to the electrical schematic and
wire harness drawings in Chapter 10 -- Foldout Draw-
ings for additional circuit information.
Testing
Make sure that ignition switch is OFF. Disconnect nega-
tive (--) battery cable from battery terminal and then dis-
connect positive (+) cable from battery (see Battery
Service in the Service and Repairs section of this chap-
ter). Locate fusible link harness and unplug fusible link
connector from wire harness. Use a multimeter to make
sure that continuity exists between the fusible link termi-
nals. If a fusible link is open, replace the fusible link har-
ness.
After testing is complete, make sure that fusible link is
securely attached to engine component and wire har-
ness. Connect positive battery cable to battery terminal
first and then connect negative cable to battery.
Electrical System
3
1. Starter solenoid
2. Fusible link harness
1. Starter solenoid
2. Alternator
Page 6 - - 34
1
2
Figure 37
3. Harness connector
2
Figure 38
3. Fusible link harness
FUSIBLE LINK
FUSIBLE LINK
FUSIBLE LINK
Figure 39
Greensmaster 3300/3400
1
3