Steering Cylinder - Toro Greensmaster TriFlex 3300 Service Manual

Steering Cylinder

60 to 80 ft- -lb
(82 to 108 N- -m)
4
9
8
RIGHT
FRONT
1. Steering cylinder
2. Frame
3. Rear steering fork
4. Jam nut (4 used)
Removal (Fig. 75)
1. Park machine on a level surface, engage the parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components in
this section.
Hydraulic System
2
10
1
6
5. Rear wheel spindle
6. Steering spindle
7. Rear wheel and tire
Page 5 - - 104
60 to 80 ft- -lb
(82 to 108 N- -m)
8
9
3
5
4
Figure 75
2. Operate all hydraulic controls to relieve hydraulic
system pressure.
3. To allow easier access to steering cylinder, raise and
support tank mount plate assembly (hydraulic reservoir,
fuel tank and tank mount plate) (see Tank Mount Plate
Assembly in the Service and Repairs section of Chapter
7 -- Chassis).
4. Label steering cylinder hydraulic hoses for assembly
purposes. Thoroughly clean hydraulic hose ends prior
to disconnecting the hoses from steering cylinder.
8. Retaining ring (2 used)
9. Ball joint (2 used)
10. Cylinder spacer
Greensmaster 3300/3400
7