Engine Bell Housing - Toro Greensmaster TriFlex 3300 Service Manual

Engine Bell Housing

3
1. Engine
2. Flange head screw (5 used)
Removal (Fig. 17)
NOTE: The hydraulic pump assembly needs to be re-
moved from engine before bell housing and coupling
flange can be removed.
1. If engine is in machine, support engine from below to
prevent it from shifting. Remove hydraulic pump assem-
bly (see Piston (Traction) Pump Removal in the Service
and Repairs section of Chapter 4 -- Hydraulic System).
2. As necessary, remove bell housing and coupling
flange from engine using Figure 17 as a guide.
Diesel Engine
4
6
2
Figure 17
3. Bell housing
4. Coupling flange
Page 4 - - 18
1
5
Installation (Fig. 17)
1. If coupling flange was removed from engine fly-
wheel, position flange to flywheel and align mounting
holes. Secure flange to flywheel with five (5) flange head
screws. Tighten screws in a star pattern.
2. If bell housing was removed from engine, make sure
that spring pin is secure in upper hole of bell housing.
Position bell housing to flywheel plate and secure with
five (5) flange head screws. Tighten screws in a star pat-
tern.
3. If engine is in machine, install hydraulic pump as-
sembly (see Piston (Traction) Pump Installation in the
Service and Repairs section of Chapter 5 -- Hydraulic
System).
FRONT
RIGHT
5. Flange head screw (5 used)
6. Dowel pin (2 used)
Greensmaster 3400