Grooming Reel - Toro Greensmaster TriFlex 3300 Service Manual

Grooming Reel (Counter Rotating Groomer Drive)
120 in- -lb
(13.5 N- -m)
125 ft- -lb
(170 N- -m)
24
17
20
22
21
10
9
3
1
2
7
1. RH groomer arm assembly
2. HOC nut (2 used)
3. Bushing (2 used)
4. Spring washer (2 used)
5. Lock nut (2 used)
6. LH groomer arm assembly
7. Cap screw (2 used)
8. Grooming reel assembly
9. HOC washer (2 used)
10. HOC screw (2 used)
11. O- -ring
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft (if not equipped with carbide blades)
or to replace the grooming shaft.
Removal (Fig. 10)
1. Park machine on a clean, level surface. Lower cut-
ting units completely to the ground, stop engine, engage
parking brake and remove key from the ignition switch.
2. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
3. Make sure that handle on groomer cover is rotated
toward front of machine so that groomer drive is en-
gaged.
Groomer
18
33
29
13
12
25
30
14
18
23
15
24
120 in- -lb
(13.5 N- -m)
12. RH drive plate assembly
13. Shoulder bolt (2 used)
14. Driven gear (30T)
15. Lock nut
16. Front roller
17. Groomer drive gear (45T)
18. Bearing (2 used)
19. RH cutting unit side plate
20. Gasket
21. Flange head screw (5 used)
22. Groomer cover assembly
27
26
31
19
5
4
13
17 to 21 ft- -lb
(23 to 28 N- -m)
Figure 10
4. Remove groomer cover assembly (item 22) and gas-
ket (item 20) from machine (see Groomer Cover (Count-
er Rotating Groomer Drive) in this section). Discard
gasket.
5. Carefully remove extension spring from anchor
points on RH drive plate (Fig. 11).
6. Remove the two (2) idler gears (43T and 47T) from
the RH drive plate assembly (Fig. 12). The bearings are
pressed into the gears.
7. Loosen cap screws (item 7) that secure front roller
shaft to groomer arms.
Page 9 - - 14
10
28
32
11
31
8
16
23. 47T idler gear
24. Flange nut (2 used)
25. Extension spring
26. Inner spring (2 used)
27. Outer spring (2 used)
28. LH support plate assembly
29. Support plate
30. Button head screw (4 used)
31. Plow bolt (2 used)
32. LH cutting unit side plate
33. 43T idler gear
Greensmaster 3300/3400
2
9
6
7
Antiseize
Lubricant