Adjustments; Adjust Manifold Relief Valves - Toro Greensmaster TriFlex 3300 Service Manual

Adjustments

Adjust Manifold Relief Valves

Both the lift and mow control manifold include an adjust-
able relief valve. If adjustment of either of these valves
is necessary, follow the following procedure.
NOTE: Do not remove relief valve from the hydraulic
manifold for adjustment.
WARNING
Never adjust the relief valve with the hydraulic
system pressurized. Hydraulic oil may spray out
of the valve when the cap is off. Personal injury
may result. Always install and tighten the cap be-
fore pressurizing the system.
1. Locate relief valve on control manifold.
2. Remove cap on relief valve with an allen wrench.
3. To increase pressure setting, turn the adjustment
socket on the valve in a clockwise direction. A 1/8 turn
on the socket will make a measurable change in relief
pressure.
4. To decrease pressure setting, turn the adjustment
socket on the valve in a counterclockwise direction. A
1/8 turn on the socket will make a measurable change
in relief pressure.
5. Install and tighten cap on relief valve.
6. Recheck relief pressure and readjust as needed.
Hydraulic System
1. Relief valve cap
Page 5 - - 54
1
2
Figure 32
2. Adjustment socket
Greensmaster 3300/3400