Western Digital My Cloud EX2 Ultra User Manual page 88

Energy Saver
The Energy Saver fields allow you to reduce the energy required to run your
My Cloud EX2 Ultra device. Use the following information to configure the energy saving
options on your My Cloud EX2 Ultra device.
View or change the following settings:
Drive Sleep
LED
Power Recovery
Power Schedule
MY CLOUD EX2 ULTRA PRIVATE CLOUD STORAGE
USER MANUAL
Enabling this function allows the hard drives to go
into standby mode to save power after a
designated period of inactivity. Drive Sleep is
enabled to sleep after approximately 10 minutes by
default.
• To enable/disable Drive Sleep, click the toggle
button .
Enabling this function allows the device LEDs to go
into standby mode to save power. LED is enabled
by default.
• To enable/disable LED, click the toggle button
.
Automatically restarts your device from a previously
unexpected shutdown due to power failure. Power
Recovery is enabled by default.
Note: If you disable this feature, your device will
not automatically power on after an
unexpected shutdown.
• To enable/disable Power Recovery, click the
toggle button .
The Power Schedule allows you to schedule
shutdowns for your My Cloud EX2 Ultra device.
1. To enable Power Schedule, click the toggle
button .
2. Click Configure.
3. Use the slider bar to configure the start and
stop times for your device.
4. Click to send the device into hibernate.
5. Click Save.
CONFIGURING SETTINGS
83