Regulatory Information
For a list of approved external antennas, see "External Antennas" on page 30.
Professional Installation Notice
To comply with FCC part 15 rules in the United States, the system must be professionally installed
to ensure compliance with the Part 15 certification. It is the responsibility of the operator and
professional installer to ensure that only certified systems are deployed in the United States. The
use of the system in any other combination (such as co‐located antennas transmitting the same
information) is expressly forbidden.
Canada
Industry Canada Compliance Statement
This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR dʹIndustrie Canada applicables aux appareils radio
exempts de licence. Lʹexploitation est autorisée aux deux conditions suivantes : (1) lʹappareil ne
doit pas produire de brouillage, et (2) lʹutilisateur de lʹappareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible dʹen compromettre le fonctionnement.
This radio transmitter (IC: 4141B‐4411OAC) has been approved by Industry Canada to operate
with the antenna types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
Le présent émetteur radio (IC: 4141B‐4411AC) a été approuvé par Industrie Canada pour
fonctionner avec les types dʹantenne énumérés ci‐dessous et ayant un gain admissible maximal et
lʹimpédance requise pour chaque type dʹantenne. Les types dʹantenne non inclus dans cette liste,
ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour
lʹexploitation de lʹémetteur.
The antennas used for this transmitter must be installed to provide a separation distance of at least
39 cm (150cm for WS‐AO‐5D23009N) from all persons and must not be co‐located or operating in
conjunction with another antenna or transmitter.
Cet équipement est conforme aux limites dʹexposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 39
cm (150cm pour WS‐AO‐5D23009N) de distance entre la source de rayonnement et votre corps.
Dynamic Frequency Selection (DFS) for devices operating in the bands 5250‐ 5350 MHz, 5470‐5600
MHz and 5650‐5725 MHz
Sélection dynamique de fréquences (DFS) pour les dispositifs fonctionnant dans les bandes 5250‐
5350 MHz, 5470‐5600 MHz et 5650‐5725 MHz
This device may not be operated in the band 5150‐5250 MHz outdoors. This band is restricted to
indoor use only to reduce potential harmful interference to co‐channel mobile satellite systems.
Ce dispositif ne peut pas être utilisé dans la bande 5150‐5250 MHz à lʹextérieur. Cette bande est
limitée à une utilisation en intérieur afin de réduire les interférences nuisibles potentiel de co‐
canal avec les systèmes mobiles par satellite.
36
Canada
Need help?
Do you have a question about the ExtremeWireless AP3965i and is the answer not in the manual?
Questions and answers