Team Losi XXX-NT AD2 Owner's Manual page 54

Step I-21 Step I-21
Step I-21 Step I-21 Step I-21
Brake Collar Install:
193
1. Snap the 4mm Ball Cup (204) onto the ball on the carburetor.
Make sure the ball is pointing toward the right side of the truck and
slightly upward.
2. Ensure the serve is centered by turning the radio and receiver
to the on position, before proceeding.
3. Press the throttle Servo Arm (190) and Throttle Servo Spline
insert (200) onto the output shaft of the servo, and secure it with the
screw included with your servo. Be sure the servo output shaft is
centered and the Servo Arm is aligned properly, as shown.
4. Insert the end of the Brake Lever (102) through the hole in the
Over-ride Slider (195) on the Brake Likage.
5. Place a Linkage Collar (192) over the end of the Brake Lever
and secure it with a 4-40 x 1/8" Set Screw (193).
*NOTE: The slider should fit loosely under the Linkage Collar
to prevent binding.
Step I-22 Step I-22 Step I-22 Step I-22 Step I-22
Throttle Return Spring Install:
1. Attach one end of the Throttle Return Spring (202) to the hole
in the Eyelet (199). Attach the other end of the spring (190) to the
middle hole closest the edge of the Servo Arm as shown.
2. Remove the Air Filter (165) from the Air Filter Boot (166). Check
to see that the Throttle Return Spring is holding the carburetor closed,
and that the linkage is not pulling the carburetor open.
3. Looking through the Air Filter Boot into the carburetor, check
the opening of the small, half-moon area near the side. This opening
should be approximately 1/32" (1mm) in the fully closed position. If it
is not, refer to your engine instructions and adjust the idle adjust-
ment screw until the opening is 1/32" (1mm) with the throttle closed.
Ba Ba g I g I
Ba g I g I
Ba Ba g I
(Contin (Contin
(Contin ued)
(Contin (Contin
Slide Slide V V V V V alv Slide alv alve Carb alv
Slide Slide alv
ued) ued)
ued)
ued)
e Carb e Carbur e Carb ur uretor ur etor etors s s s s etor
e Carb ur etor
192
193
102
190
190
50
Figure I-21
202
199
Figure I-22
204