Team Losi XXX-NT AD2 Owner's Manual page 29

Step E-20 Step E-20
Step E-20 Step E-20 Step E-20
Rear Shock Tower Assembly:
35
1. Insert two 4-40 x 7/8" Cap-Head Screws (33), one on each side
of the Rear Shock Tower (123), through the outer holes in the Rear
Shock Tower. The Screw should point towards the rear of the truck as
shown in Figure E-20.
2. Secure the 4-40 x 7/8" Cap-Head Screws in the Rear Shock
Tower, by threading a 4-40 Nut (35) over each Screw and tightening.
Use the included Team Losi Wheel Nut Wrench to
secure the 4-40 nuts which can also be used to adjust the Slipper
Clutch, or remove the wheel Nuts.
3. Thread a 3/8" Ball Stud (38) into the center hole on each side of
the Rear Shock Tower.
Step E-21 Step E-21 Step E-21
Step E-21 Step E-21
Rear Shock Tower Install:
9
1. Place the rear Shock Tower (123) over the rear of the Gearbox
assembly (82)(83) so the holes in the Shock Tower line up with the
holes in top of the Gearbox.
*NOTE: The rear Shock Tower should fit tightly around the Gear-
box, double check to make sure the holes are lined up properly
before threading the screws in before proceeding.
2. Place a gold Ball Stud Washer (9) over each of the 4-40 x 1/2"
Cap-Head Screws (31). Secure the rear Shock Tower to the Gearbox
by threading the 4-40 x 1/2" screws and Washers through the Shock
Tower and into the Gear Box.
B B B B B A A A A A G E (Contin G E (Contin G E (Contin
G E (Contin G E (Contin ued)
38
33
31
ued) ued)
ued) ued)
33
38
31
9
82
25
35
123
Figure E-20
123
83
Figure E-21