Shock Assembly - Team Losi XXX-NT AD2 Owner's Manual

Step F-1 Step F-1
Step F-1 Step F-1 Step F-1

Shock Assembly:

130
1. Place a drop of Shock Fluid (132) on the grooved end of each
Shock Shaft [front (130), rear (131)]. Then slide a Shock Shaft through
the hex shaped end of the Shock Cartridge (114). Slide the Shock
Shaft through until it is approximately midway between the threads
and grooves, as shown in Figure F-1.
Step F-2 Step F-2
Step F-2 Step F-2 Step F-2
Shock End Install:
121
IMPORTANT NOTE: Use caution when threading the Shock
Shaft Ends onto the Shafts. Avoid gouging or scratching the Shock
Shaft while gripping the Shock Shaft with pliers. By placing the edge
of a towel over the shaft, then gripping the portion of the Shaft cov-
ered by the towel. This method will work very well to protect the
Shock Shafts from damage.
1. Using needle nose pliers, or small vise grips, grasp the front
Shock Shaft (130) between the grooves and thread a Shock End (133)
all the way onto the Shaft.
2. Repeat Step 1 for the second front Shock Shaft and both rear
Shock Shafts (131).
3. Carefully snap a 1/4" Shock Mount Ball (121) into each of the
Shock Ends.
B B B B B A A A A A G F G F G F
G F
G F
131
121
130
28
130 131
Figure F-1
133
Figure F-2
114
131