Team Losi XXX-NT AD2 Owner's Manual page 34

Step F-5 Step F-5
Step F-5 Step F-5 Step F-5
Shock Adjustment Nut Assembly:
*Note: This step will only be used for mainte-
nance purposes. These come pre-assembled in the kit.
*NOTE: Place a drop of Shock Fluid onto each O-ring before
installing it into the Shock Adjusting Nut.This will allow the Nut
to thread onto the Shock Body easily.
1. Place the O-ring (126) into the grove inside of the Shock Ad-
justing Nut (139), Be sure to seat the O-ring completely into the groove
as shown in Figure F-5B.
Step F-6 Step F-6 Step F-6 Step F-6 Step F-6
Spring Install:
1. Snap a Shock Spring Cup (140) onto each of the four Shock
Shafts (130) (131) and slide it down around the Shock End (133).
2. Slide a red Shock Spring (141) over each of the shorter front
Shocks so that the Spring rests on the Spring Cup. Slide a pink rear
Spring (163) over the longer rear Shocks so that the Spring rests on
the Spring Cup.
3. Thread a Shock Spring Adjustment Nut (139), with the hex end
pointing up, on to the top of all four Shock Bodies (137), (138). Tighten
the Shock Adjustment Nuts on to the Shocks until the nut just
touches the Spring.
*NOTE: Final adjustment will be made later in the ride height sec-
tion in the tips portion of the manual.
B B B B B A A A A A G F (Contin G F (Contin G F (Contin
G F (Contin ued)
G F (Contin
ued) ued)
ued)
ued)
126
Figure F-5A
141
163
140
30
139
SECTIONED VIEW OF
ASSEMBLED NUT WITH
O-RING PROPERLY
SEATED IN GROOVE.
Figure F-5B
139
137
138
130
131
133
Figure F-6