Team Losi XXX-NT AD2 Owner's Manual page 52

Step I-16 Step I-16 Step I-16
Step I-16 Step I-16
Throttle Linkage Assembly:
193
1. Thread the 4mm Ball Cup (204) all the way onto the end of the
Threaded Throttle Rod (203). Slide a Linkage Collar (192) over the
other end of the Throttle Rod, and up against the Ball Cup. Secure the
collar with a 4-40 x 1/8" Set Screw (193).
2. Place the Throttle Over-ride Spring over the rod and against
the Collar. Slide a plastic Over-ride Slider (195) onto the rod, so that
the long end is away from the Ball Cup.
3. Place a Linkage Collar over the end of the rod, so the springs
are not compressed, and secure it with a 4-40 x 1/8" Set Screw. The
collar should be positioned at the end of the rod. Final adjustments
will be made later.
Step I-17 Step I-17 Step I-17 Step I-17 Step I-17
Brake Z-Bend Assembly:
193
1. Slide a Linkage Collar (192) over the end of the long, Brake Z-
bend Wire (197), and position it approximately 1/4" (60mm) from the
Z-bend. Secure the Linkage Collar in place with a 4-40 x 1/8" Set
Screw (193).
2. Slide a plastic Over-Ride Slider (195) onto the wire, so that the
long end is towards the Z-bend. Place a 0.5" piece of Fuel Tubing
(176) over the wire and against the slider.
3. Slide a Linkage Collar over the end of the wire until it just
touches the Fuel Tubing. Secure it with a 4-40 x 1/8" Set Screw. Once
again, final adjustments will be made later.
Ba Ba g I Ba g I g I g I
Ba Ba g I
Slide V V V V V alv Slide Slide alv alve Carb alv
Slide Slide alv
NOTE: If your engine comes equipped with a slide valve carburetor, complete
the steps in Figure I-16 through Figure I-22.
(Contin (Contin ued) (Contin ued) ued) ued)
(Contin (Contin ued)
e Carb e Carbur e Carb ur uretor ur etor etors s s s s etor
e Carb ur etor
204
203
193
176
192
195
48
193
192
194
Figure I-16
193
197
192
Figure I-17
195
193
192