Team Losi XXX-NT AD2 Owner's Manual page 12

Step C-3 Step C-3
Step C-3 Step C-3 Step C-3
Servo Mounting Chart:
Figure C-3A
Figure C-3B
Step C-4 Step C-4 Step C-4 Step C-4 Step C-4
Servo Mounting Post Install:
23
1. Use the tables in Figure C-3A and C-3B (Shown above) to
determine how the servo mounting posts (24) should be attached to
the servo (not included).
Trim any flashing from the pins on the mounting posts
so that they will seat all the way into the holes in the chassis brace
and chassis.
2. Place a #4 washer (23) over each of the four 4-40 x 3/8" cap-
head screws (17) and attach the servo posts to the servo by thread-
ing a screw through the upper and lower holes in each post. Do not
tighten the screws yet! Just snug them up so that the posts are held
in place, but can still be moved from side to side with a little resis-
tance. The screws will be tightened after the servo is installed so that
the posts have the correct spacing.
Place a Body Clip between the servo case and servo
Mounting Post before tightening the mounting screws. Center the
posts vertically and tighten the four mounting screws. For most servo
manufactures this will space the servo mounting posts perfectly.
B B B B B A A A A A G C (Contin G C (Contin G C (Contin
G C (Contin ued)
G C (Contin
NES-507, NES-513, NES-517, NES-901,
** Use 1 Ball Stud washer on the ball stud when attaching it to the servo arm.
17
SERVO TYPE
AIRTRONICS
All
Futaba
S131, S131SH, S148, S3001, S5101,
S9101,S9201, S9301, S9401, S9403
Futaba
S3401, S9402, S9404, S9450
Futaba
S9303
HiTech
HS-605, HS-615, HS-925, HS-945
HiTech
All other's
JR
NES-4000, NES-4131, NES-4721,
NES-4735, NES-9021,DS-8231
KO
PS-702, PS-703, PS-1001, PS-1003
KO
PS-901BH, PS-902
Multiplex
All
24
9
ued) ued)
ued)
ued)
MOUNTING POST REQUIRED
PIN LOCATION SERVO ARM
1 or 3
2
3
4**
3**
1
1
2
1
3
Table C-3C
Figure C-4
STEERING LINK
LENGTH
23 C-6A
25 C-6A
25 C-6A
25 C-6A
24 C-6B
24 C-6B
23 C-6A
23 C-6A
23 C-6A
23 C-6A
23
17